My Toilet Is Blocked, How Do I Fix It?
A blocked toilet usually does not mean that you are facing a major drainage failure – all going well, it is just a temporary nuisance that you can fix yourself. However, some can be trickier than others, so we are going to outline some techniques to get everything running smoothly from using a simple plunger to employing effective but damaging chemicals.
1 Plunging
In all honesty, we probably don’t have to go into too much detail here. We should all have a good idea of how a plunger works. However, here are some quick tips:
Buy a good quality plunger. If you buy a cheap one, and it doesn’t work, you will end up spending more money in the long-run and having to wait longer to have your toilet unblocked.
Start with a gentle plunge as initially the bell is just filled with air. From here, push and pull with force.
Ensure that the plunger is covered with water the whole time, and make sure you maintain the seal!
All going well, after a little bit of effort you will force the blockage down and you will hear the water running again. Remember to wear gloves!
2 An Auger
When a plunger just won’t cut it, you need to upgrade to something more sophisticated. That is where an auger or ‘plumbing snake’ could do the trick. Available on Amazon or in any tool/DIY shop, these tools can really make the difference and do the job where a plunger fails. Here is a brief overview of how the process works:
Place the wire casing into the toilet and feed the auger down the toilet pipe. You should not be able to see the actual wire portion when you begin the process.
Place one hand on the auger housing and turn the handle slowly with the other to work the auger down the drain. Be patient: Wind it down slowly or else it will just turn back on itself and back towards you!
If the auger stops moving down the drain, reverse crank a couple of times to free it up, and then begin cracking it normally again. Eventually the auger handle should be very tight against the auger tube. At this stage, crank it a few more times.
All going well, the blockage will have cleared. Flush the toilet to make sure and if it does not work you may want to try again a couple of times.
Remember to wipe the auger dry when you are finished so that it does not rust when in storage!
3 Chemicals
If manual processes don’t work, you might have to resort to chemicals. You have two options.
Firstly, you can use an enzyme cleaner. This is preferable if you know that the blockage is organic. Enzyme cleaners will only work on organic substances which means they will do no harm to your pipes, although they will not work if the blockage is plastic or metal etc.
Alternatively, you can use a drain cleaner. This can make short work of anything causing troubles in your pipes – but it will also make quick work of your pipes. Because it is corrosive, it will target things indiscriminately, reducing the lifespan of your pipes with every use.





Comments